Cord Drawn Curtain Tracks Instructions

3 unhook cord from master carrier and allow to drop inside track.

Cord drawn curtain tracks instructions. Curtain track features and how to install. Fitting instructions for styletrack track if installing into plaster or wallboard where possible try and pick up a timber stud. Most curtain tracks do not have the mounting holes pre drilled. Once you have worked out were your track is going to go.

Then remove master carrier from the track. Measure also the distance from the floor to the top of the curtain rod. If you re removing an old cord you can untie it. I have fitted a metal white curtain track with cord attachments and runners but finding it very difficult to correctly hang the curtains problem overlaper runner hope you can help pulling my hair out thanks.

Click here for how to mend it. Installing your styletrack curtain track. Hook cord over the lug on carrier 2 to secure it. Then feed cord around and over the top pulley g pass cord back through ovelrap master slide.

If unable to locate a timber stud use a suitable wall plug or toggle for hollow walls to hold your bracket. How to fit new cord to curtain tracks take measurements. Replace sliders at each end. How to thread cord on curtain rails.

Tension cord and tie off h. Re attach track onto brackets and re hang curtains. Pass the cord over the central bridge on slave master slide f twist cord to create a loop and hook over centre tab f pass cord over the top of the bottom pulley in opposite end pulley. Next place the rod face down on a flat surface.

Remove the curtain rod from the. Cord on overlap master carrier as original. Add those two. 2 pull track apart at the centre.

To drill holes identify where the holes should be positioned and mark the track. Standard drill bits work fine on all aluminum tracks. First you ll want to remove the curtain along with the curtain hooks from the rod and carriers. Remove the curtains from the traverse rods so you can access the cording.

Draw the cord until the right hand carrier 1 is as far to the right as possible. 8conversion to one way draw right hand conversion drapes drawn from left to right 1 lay track face down on the floor. Holding the cords taut push carrier 2 as far to the left as possible.